Precautions for installing the fingerprint lock.
Because the door opening method of the lock is different, the hole position of the installation mold is also different. Therefore, you must first determine which holes on the installation mold need to be opened according to the door opening method of the lock before marking. Special attention should be paid to the direction of the front and back conductors, sockets and plugs of the fingerprint lock to ensure the correct connection. Before installation, you must first confirm the height of the fingerprint lock. After determining the height, use the installation mold to stick to the photo and draw the position of the opening with a pencil. When drawing holes, the folding edge of the installation mold must be perpendicular to the door frame, otherwise the lock body will not be perpendicular to the door after installation. In general, the lock cylinder is required to be installed in the middle of the door thickness.
1. Keep the lock body clean and tidy.
Do not drop wood chips or iron chips into the lock body from the gap of the lock body, otherwise it will cause the short circuit of the electronic components or the jam of other components.
2. Installation of the lock core of the fingerprint lock.
When the lock core of the fingerprint lock is installed in the mounting hole, the surface of the lock core cannot be higher than the surface of the door frame, and should be on the same plane.
3. Installation of the gusset.
The hole position of the gusset plate must correspond to the position of the lock tongue. If the correspondence is not symmetrical, the door will loose or cannot be closed, and the safety tongue cannot be inserted into the gusset plate hole.
4. The lock body installation of the fingerprint lock.
The screws must be fastened in place, and no gap should be left between the lock body and the door.
5. Connection of wires.
The wire connection must be correct and the connection must be firm, otherwise the door lock will not work properly.
1. Keep the lock body clean and tidy.
Do not drop wood chips or iron chips into the lock body from the gap of the lock body, otherwise it will cause the short circuit of the electronic components or the jam of other components.
2. Installation of the lock core of the fingerprint lock.
When the lock core of the fingerprint lock is installed in the mounting hole, the surface of the lock core cannot be higher than the surface of the door frame, and should be on the same plane.
3. Installation of the gusset.
The hole position of the gusset plate must correspond to the position of the lock tongue. If the correspondence is not symmetrical, the door will loose or cannot be closed, and the safety tongue cannot be inserted into the gusset plate hole.
4. The lock body installation of the fingerprint lock.
The screws must be fastened in place, and no gap should be left between the lock body and the door.
5. Connection of wires.
The wire connection must be correct and the connection must be firm, otherwise the door lock will not work properly.